132 Preset helicopter settings
For a given set of helicopters StudioX offers preset setups. In case you have the exact same
helicopter with similar electronic setup (i. e. servos, ESC, ...) you can load the preset for
your helicopter to your BEASTX flybarless device. So it is not necessary to go through
the basic setup routine as your device will be readily setup by loading the preset. Anyhow,
you must make sure your radio setup is done properly and that all control commands on
the radio are working as expected. Also it may be nessary to readjust the servo center
positions, either using the quick adjust option in PARAMETER MENU or the single
trimm option of SETUP MENU. Last but not least it is absolutely mandatory that your
BEASTX device is mounted in the exact same position is defined by the given preset.
Otherwise the correction of the system will go into the wrong direction. In case your device
is mounted differently, you must check and readjust device orientation in SETUPMENU!
Figure 176
Figure 177
315
To Next Page
Loading...
