BEASTX flybarless system
can be helpful to close the app completely, disconnect and reconnect the
BLE2SYS and start over again!
Also note that the device name can be different! By default it's ”BLE2SYS”, but as it's
possible to change the bluetooth id, it maybe different. (The automatic deactivation
time as well as the bluetooth id can be changed in the configuration menu by clicking
the BLE2SYS button above the device selection box.)
129.2 Overview screen
When connection to your BEASTX device is established, wait until the data is loaded from
the device and initialization sequence is finished. At first the system will calibrate to the
radio system, Menu LEDs H to N will cycle up and down at the device (MICROBEAST
PLUS/AR7210BX) and you can read Radio init in the opening overview screen. During
this time do not move the sticks on your radio as the system is learning the stick
mid positions! In the second step the device checks if the sensors are working correctly
and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down
(MICROBEAST PLUS/AR7210BX) and you can read Sensor init in the opening
overview screen. During this time do not move the helicopter! When initialization is
completed, the Status LED will change to blue or purple color indicating the current gyro
mode and you can read the gyro gain and mode in the app.
To be able to access all settings wait until your device has passed initialization sequence.
If it doesn't, probably receiver setting is wrong. So start with the CONTROL SETUP.
If you can't get through the initialization sequence either because LEDs A-G or LEDs
H-N don't stop cycling, please read the FAQ
2
and do the CONTROL SETUP first (see
manual of your device for further instructions).
2
https://wiki.beastx.com/./index.php/Help:FAQ:Powerup/en
310
To Next Page
Loading...
