123 Information about firmware versions
This page is a translated version
1
of the page Manuals:MBPlusFblV52:VersionInfo
2
and the
translation is 100% complete.
The software that is installed on your MICROBEAST PLUS controller is what we call a
”firmware”. This firmware can be updated (i.e. for improvements, fixes, new features, ...)
by downloading a file from the internet and flashing this on the device. To distinguish
between firmware files each firmware has a unique version number ”X.Y.Z” where ”X” is the
major version, ”Y” is the minor version and ”Z” is the patch version. You can say that when
the major version (”X”) changes then a lot will be different between two versions. When
minor version ”Y” increases, there will be a few new features or parameters. A change in
”Z” is only a patch or fix that shouldn't be greatly noticable expect for some very little
improvements. From the changelog below you can find out differences between versions.
In general it is always recommended to stay with the latest version as this should give you
the most features and benefits.
1
https://wiki.beastx.com/index.php?title=Special:Translate&group=page-Manuals%
3AMBPlusFblV52%3AVersionInfo&action=page&filter=&language=en
2
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:VersionInfo
295
To Next Page
Loading...
