Adjustment on the device
3. Optional: When you move the rudder stick to full deflection, the Status LED should
light solid, not just flash. If this is not the case, increase the servo throw/endpoint
of the rudder channel in the transmitter just as far so that the Status LED
changes from flashing to solid when the rudder stick reaches the end position.
(Note: Do not increase the endpoint too much in the transmitter. We need an exact match
of full stick position and stick end position. So the Status LED should just change from
flashing to solid when raching the end position.)
Always set servo direction in the transmitter first, then check the display on the
MICROBEAST PLUS or in the software and change the internal control direction if it
does not match the real direction. Do not change the internal direction in order
to change the servo direction! This is only used for telling the gyro in which
direction it must move the servo. Be very conscientious when doing this setup
step, as wrong gyro direction will cause loss of control during takeoff and you probably
crash the helicopter!
In addition you can check the gyro direction by turning the helicopter by
hand around its vertical axis. When turning the heli the gyro must move the servo
so that the rotor will produce a counter action agains the turn direction. So later in
flight the gyro will stop the helicopter from unwanted movement. Here the LED will
light up in blue color when you turn the helicopter to the right and light up in red
when you turn it to the left. So you can get a little reminder when you do not know
which is the correct stick direction to setup, when you need to do the setup later on the
field!
104
To Next Page
Loading...
