Setup with StudioXm
Always set servo direction in the transmitter first, then check the display on the
MICROBEAST PLUS or in the app and change the internal control direction if it does
not match the real direction. Do not change the internal direction in order to
change the servo direction! This is only used for telling the gyro in which
direction it must move the servo. Be very conscientious when doing this setup
step, as wrong gyro direction will cause loss of control during takeoff and you probably
crash the helicopter!
In addition you can check the gyro direction by turning the helicopter by
hand around its vertical axis. When turning the heli the gyro must move the servo
so that the rotor will produce a counter action agains the turn direction. So later in
flight the gyro will stop the helicopter from unwanted movement.
106
To Next Page
Loading...
