Adjustment at the device
that is used when bank switching is disabled!
When using predefined control behaviors other than ”transmitter” we do not
recommend to additionally adjust control curves (Expo/Dual rates) in your transmitter
as this will indefinably mix the preset curves of MICROBEAST PLUS with the curves
of the transmitter! Anyhow, if you only make small adjustments (e.g. slightly increasing
the throw to increase rotation rate) this should be no problem.
If the tail gyro is operated in Normal-Rate mode the rudder stick directly controls
the rudder servo instead of commanding a rotation rate to the gyro. In this mode the
heli will turn as fast as it is determined by the rudder servo position and angle of attack
of the rotor blades. The tail gyro does not monitor the rate of rotation. Therfore it is
possible to get very high rotation rates and it is absolutely necessary to check how much
pitch angle will be achieved at full rudder stick deflection at the tail rotor. Reduce the
servo throw of the rudder servo by decreasing it on the remote control or limiting it on
the MICROBEAST PLUS to a reasonable level.
230
To Next Page
Loading...
