Fine tuning of AttitudeControl
• In case the helicopter is not aligned horizontally as desired with active AttitudeControl,
i. e. drifts to one side in hovering, the artificial horizon can be readjusted. This is done
in Quicktrim Menu at PARAMETER MENU point A or by changing the trim with the
StudioX software or StudioXm app. When the positioning seems to vary randomly and
the tilt gets a huge offset the longer you fly, this can be due to bad position measure-
ment. The cause for this can be high frequent vibrations, fluctuations in temperature or
misalignment of the device. On the other hand please note that minor deviations are
inherent. When you feel the artifical horizon gets some little offset after some time let
the heli stay in hover position for a few seconds without touching the sticks. Usually the
horizon will recalibrate automatically then (as long as the vibration level is not too high).
271
To Next Page
Loading...
