Update procedure
few seconds until the firmware file was generated individually for your device. Once this
is done, again click the button to Download and Flash the firmware. Before this happens
you will be asked one last time, if you are really sure you want to flash a new firmware
to your device. Please note: Flashing from a different major version (i.e. updating from
V4.x.x to V5.x.x) will erase all settings of your device and you will have to do all the setup
again. This is because typically a new major version will be created when the whole setup
procedure has changed are a bunch of new settings and parameters will be added to the
firmware, so the old setup is not applicable to the new firmware anymore. So also make
sure you've read and understood the manual for the new firmware as well!
The firmware procedure should start immediately after pressing the OK button. During
the update please do not do anything! Just wait until the progress has gone up to 100%,
which will take a few seconds when using a computer with USB2SYS and may take 1
or 2 minutes when using a smartphone with BLE2SYS bluetooth connection. When
using the bluetooth keep your smartphone/tablet in very close distance to the BLE2SYS
module (just a few inches) as the bluetooth connection can be interrupted easily. Also it
is advisable to keep the radio system switched off when performing the update and stay
aways from other radio devices like wifi routers or similar. When the procedure has finished
your device will reboot and StudioX/StudioXm will close the connection. Now you can
connect again and start over with the setup.
330
To Next Page
Loading...
