Setup with StudioX
• during initialization when the transmitter was not switched on before or was switched on
too late and the radio link between transmitter and receiver is not established yet
Additionally the failsafe position is used by the internal Governor function in case you're
using a helicopter with electric drive system. Here the throttle is moved to the stored
failsafe position when you set the Governor to Autorotation bailout mode!
Note:
• The fail-safe function is not effective if the receiver continues sending data even if the
radio link is interrupted. In this case the failsafe setting of the remote control system
may take precedence.
• To avoid accidents, you should program electric motors to “off“ and reduce throttle on
nitro helicopters to idle. The other control functions will be set to „position hold“ in case
of signal interruption. For these setting a failsafe position is not provided.
To teach the failsafe position choose ”Proceed” when asked to teach the failsafe position
and set the throttle channel on your remote control to the desired position. Then press
Set to save the position. If you did not connect a function to CH5 Output and don't need
throttle failsafe, press Cancel to complete setup!
After function assignment click Proceed to start teaching the throttle failsafe position
Move throttle to lowest position at which the motor is turned off
Click Set to store the setting
During failsafe setting the CH5 Output is enabled and can be controlled
by the transmitter channel that is assigned to throttle function. This allows to
check your throttle position in reality. When using electric models make sure the motor
is disconnected from the ESC or the pinion is removed from the motor, so that it will
not drive the model by accident.
64
To Next Page
Loading...
