5
Loading Paper
5-7
Routine Maintenance
3
Squeeze the lever on the front guide, as shown below. Without
releasing the lever, slide the front guide to align it with the mark for
the desired paper size.
IMPORTANT
•
Not adjusting the guides correctly may cause paper jams, dirty prints, or make the inside of
the machine dirty. To prevent these problems, check that the guides are adjusted correctly for
the loaded paper size.
4
Set the size switch to match the paper being loaded.
“INCH”: For Inch series paper
“A/B”: For A/B series paper
If you change the setting of the size switch, replace the label on the paper size dial,
accordingly.
IMPORTANT
•
Not setting the size switch correctly, results in the display of an incorrect paper size on the
touch panel display. Also, it may cause paper jams, dirty prints, or make the inside of the
machine dirty. To prevent these problems, check that the size switch is set correctly.
Front Guide
INCH
A/B
E1L_US_U_.book-INDEX Page 7 Wednesday, May 23, 2001 11:40 PM
To Next Page
Loading...
