EasyManuals Logo

Cisco 500 Series Administration Guide

Cisco 500 Series
653 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
Administration: Discovery
Configuring CDP
Cisco 500 Series Stackable Managed Switch Administration Guide 172
9
• Syslog Native VLAN Mismatch—Select to enable sending a SYSLOG
message when a native VLAN mismatch is detected. This means that the
native VLAN information in the incoming frame does not match what the local
device is advertising.
• Syslog Duplex Mismatch—Select to enable sending a SYSLOG message
when duplex information mismatch is detected. This means that the duplex
information in the incoming frame does not match what the local device is
advertising.
STEP 3 Enter the relevant information, and click Apply. The port settings are written to the
Running Configuration.
CDP Local Information
To view information that is advertised by the CDP protocol about the local device:
STEP 1 Click Administration > Discovery - CDP > CDP Local Information.
STEP 2 Select a local port, and the following fields are displayed:
• Interface—Number of the local port.
• CDP State—Displays whether CDP is enabled or not.
• Device ID TLV
- Device ID Type—Type of the device ID advertised in the device ID TLV.
- Device ID—Device ID advertised in the device ID TLV.
• System Name TLV
- System Name—System name of the device.
• Address TLV
- Address1-3—IP addresses (advertised in the device address TLV).
• Port TLV
- Port ID—Identifier of port advertised in the port TLV.
• Capabilities TLV
- Capabilities—Capabilities advertised in the port TLV)

Table of Contents

Other manuals for Cisco 500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 500 Series and is the answer not in the manual?

Cisco 500 Series Specifications

General IconGeneral
ModelCisco 500 Series
CategorySwitch
MountingRack-mountable
ManagementWeb-based, CLI, SNMP
Ports24, 48
Port Speed10/100/1000 Mbps
PoE SupportAvailable on some models
Switching CapacityUp to 176 Gbps
MAC Address Table Size16, 000 entries
SecurityACLs, 802.1X
Quality of Service (QoS)Yes
DimensionsVaries by model
WeightVaries by model
Humidity10% to 90% non-condensing
Power SupplyInternal
Power ConsumptionVaries by model
Jumbo Frame SupportUp to 9216 bytes

Related product manuals