Cisco 500 Series Administration Guide

Smartport
Smartport Types
215 Cisco 500 Series Stackable Managed Switch Administration Guide
12
• Statically from a Smartport macro by name only from the CLI.
A Smartport macro can be applied by its Smartport type statically from CLI and
GUI, and dynamically by Auto Smartport. Auto Smartport derives the Smartport
types of the attached devices based on CDP capabilities, LLDP system
capabilities, and/or LLDP-MED capabilities.
The following describes the relationship of Smartport types and Auto Smartport
Special Smartport Types
There are two special Smartport types; default and unknown. These two types
are not associated with macros, but they exist to signify the state of the interface
regarding Smartport.
The following describe these special Smartport types:
• Default
An interface that does not (yet) have a Smartport type assigned to it has the
Default Smartport status.
Smartport Type Supported by Auto
Smartport
Supported by Auto
Smartport by default
Unknown No No
Default No No
Printer No No
Desktop No No
Guest No No
Server No No
Host Yes No
IP camera No No
IP phone Yes Yes
IP phone desktop Yes Yes
Switch Yes Yes
Router Yes No
Wireless Access
Point
Yes Yes

Cisco 500 Series Specifications

General

Model	Cisco 500 Series
Category	Switch
Mounting	Rack-mountable
Management	Web-based, CLI, SNMP
Ports	24, 48
Port Speed	10/100/1000 Mbps
PoE Support	Available on some models
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Security	ACLs, 802.1X
Quality of Service (QoS)	Yes
Dimensions	Varies by model
Weight	Varies by model
Humidity	10% to 90% non-condensing
Power Supply	Internal
Power Consumption	Varies by model
Jumbo Frame Support	Up to 9216 bytes