Cisco 500 Series - Mld Proxy

Multicast
IPv6 Multicast Configuration
Cisco 500 Series Managed Switch Administration Guide 334
17
STEP 2 To configure a VLAN, select it and click Edit. Enter the fields described above.
STEP 3 Click Apply. The Running Configuration file is updated.
MLD Proxy
NOTE This page is only found on SG500X/SG500XG devices.
To configure MLD Proxy:
STEP 1 Click Multicast > IPv6 Multicast Configuration > MLD Proxy.
STEP 2 Enter the following fields:
• MLD Multicast Routing—Select to enable IPv6 Multicast routing.
• Downstream Protection—Select to discard downstream packets not
required for the device.
• Source Specific Multicast—Select to enable delivering Multicast packets
originating from a specific source address defined in the next field.
• SSM IPv6 Access List—Define the list containing source addresses from
which to deliver Multicast packets:
- Default List—Defines the SSM range access list to FF3E::/32.
- User defined access list—Select the standard IPv6 access list name
defining the SSM range. These access lists are defined in IPv6 Access
Lists.
STEP 3 Click Apply. The Running Configuration file is updated.
To add protection to a VLAN, click Add and enter the following fields:
• Upstream Interface—Select the outgoing interface.
• Downstream Interface—Select the incoming interface.
• Downstream Protection—Select one of the following options:
- Use Global—Use the status set in the global block.
- Disable—This disables forwarding of IPv6 Multicast traffic from
downstream interfaces.
- Enable—This enables forwarding from downstream interfaces.