Cisco 500 Series - SSH Client; Configuring TCP;UDP Services

Security
SSH Client
455 Cisco 500 Series Stackable Managed Switch Administration Guide
21
SSH Client
See Security: SSH Client.
Configuring TCP/UDP Services
The TCP/UDP Services page enables TCP or UDP-based services on the device,
usually for security reasons.
The device offers the following TCP/UDP services:
• HTTP—Enabled by factory default
• HTTPS—Enabled by factory default
• SNMP—Disabled by factory default
• Te l n e t —Disabled by factory default
• SSH—Disabled by factory default
The active TCP connections are also displayed in this window.
To configure TCP/UDP services:
STEP 1 Click Security > TCP/UDP Services.
STEP 2 Enable or disable the following TCP/UDP services on the displayed services.
• HTTP Service—Indicates whether the HTTP service is enabled or disabled.
• HTTPS Service—Indicates whether the HTTPS service is enabled or
disabled.
• SNMP Service—Indicates whether the SNMP service is enabled or
disabled.
• Te l n e t S e r v i c e —Indicates whether the Telnet service is enabled or disabled.
• SSH Service—Indicates whether the SSH server service is enabled or
disabled.
STEP 3 Click Apply. The services are written to the Running Configuration file.