Cisco 500 Series Administration Guide

Security
Defining Users
429 Cisco 500 Series Stackable Managed Switch Administration Guide
21
• Configuring TACACS+
• Configuring RADIUS
• Configuring Port Security
• 802.1X
• Time Range
Protection from other network users is described in the following sections. These
are attacks that pass through, but are not directed at, the device.
• Denial of Service Prevention
• DHCP Snooping
• SSL Server
• Defining Storm Control
• Configuring Port Security
• IP Source Guard
• ARP Inspection
• Access Control
• First Hop Security
Defining Users
The default username/password is cisco/cisco. The first time that you log in with
the default username and password, you are required to enter a new password.
Password complexity is enabled by default. If the password that you choose is not
complex enough (Password Complexity Settings are enabled in the Password
Strength page), you are prompted to create another password.
Setting User Accounts
The User Accounts page enables entering additional users that are permitted to
access to the device (read-only or read-write) or changing the passwords of
existing users.
After adding a level 15 user (as described below), the default user is removed
from the system.

Cisco 500 Series Specifications

General

Model	Cisco 500 Series
Category	Switch
Mounting	Rack-mountable
Management	Web-based, CLI, SNMP
Ports	24, 48
Port Speed	10/100/1000 Mbps
PoE Support	Available on some models
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Security	ACLs, 802.1X
Quality of Service (QoS)	Yes
Dimensions	Varies by model
Weight	Varies by model
Humidity	10% to 90% non-condensing
Power Supply	Internal
Power Consumption	Varies by model
Jumbo Frame Support	Up to 9216 bytes