Cisco 500 Series Administration Guide

IP Configuration
IPv4 Management and Interfaces
Cisco 500 Series Managed Switch Administration Guide 362
18
DHCP Snooping Along With DHCP Relay
If both DHCP Snooping and DHCP Relay are globally enabled, then if DHCP
Snooping is enabled on the client's VLAN, DHCP Snooping rules contained in the
DHCP Snooping Binding database are applied, and the DHCP Snooping Binding
database is updated in the client's and DHCP server’s VLAN, for packets that are
relayed.
DHCP Default Configuration
The following describes DHCP Snooping and DHCP Relay default options.
DHCP Default Options
Configuring DHCP Work Flow
To configure DHCP Relay and DHCP Snooping:
DHCPRELEASE Same as
DHCPDECLINE.
Same as DHCPDECLINE.
DHCPINFORM Forward to trusted
interfaces only.
Forward to trusted interfaces
only.
DHCPLEASEQUE
RY
Filtered. Forward.
Packet Type Arriving from
Untrusted Ingress
Interface
Arriving from Trusted Ingress
Interface
Option Default State
DHCP Snooping Enabled
Option 82 Insertion Not enabled
Option 82 Passthrough Not enabled
Verify MAC Address Enabled
Backup DHCP Snooping
Binding Database
Not enabled
DHCP Relay Disabled

Cisco 500 Series Specifications

General

Model	Cisco 500 Series
Category	Switch
Mounting	Rack-mountable
Management	Web-based, CLI, SNMP
Ports	24, 48
Port Speed	10/100/1000 Mbps
PoE Support	Available on some models
Switching Capacity	Up to 176 Gbps
MAC Address Table Size	16, 000 entries
Security	ACLs, 802.1X
Quality of Service (QoS)	Yes
Dimensions	Varies by model
Weight	Varies by model
Humidity	10% to 90% non-condensing
Power Supply	Internal
Power Consumption	Varies by model
Jumbo Frame Support	Up to 9216 bytes