EasyManuals Logo

Cisco 500 Series Administration Guide

Cisco 500 Series
653 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #438 background imageLoading...
Page #438 background image
Security
Configuring TACACS+
Cisco 500 Series Stackable Managed Switch Administration Guide 436
21
• Source IPv4 Interface—Select the device IPv4 source interface to be
used in messages sent for communication with the TACACS+ server.
• Source IPv6 Interface—Select the device IPv6 source interface to be
used in messages sent for communication with the TACACS+ server.
NOTE If the Auto option is selected, the system takes the source IP address
from the IP address defined on the outgoing interface.
STEP 4 Click Apply. The TACACS+ default settings are added to the Running
Configuration file. These are used if the equivalent parameters are not defined in
the Add page.
STEP 5 To add a TACACS+ server, click Add.
STEP 6 Enter the parameters.
• Server Definition—Select one of the following ways to identify the
TACAC S+ s e r ver :
- By IP address—If this is selected, enter the IP address of the server in
the Server IP Address/Name field.
- By name—If this is selected enter the name of the server in the Server IP
Address/Name field.
• IP Version—Select the supported IP version of the source address: IPv6 or
IPv4.
• IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—Select the link local interface (if IPv6 Address Type
Link Local is selected) from the list.
• Server IP Address/Name—Enter the IP address or name of the TACACS+
server.

Table of Contents

Other manuals for Cisco 500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 500 Series and is the answer not in the manual?

Cisco 500 Series Specifications

General IconGeneral
ModelCisco 500 Series
CategorySwitch
MountingRack-mountable
ManagementWeb-based, CLI, SNMP
Ports24, 48
Port Speed10/100/1000 Mbps
PoE SupportAvailable on some models
Switching CapacityUp to 176 Gbps
MAC Address Table Size16, 000 entries
SecurityACLs, 802.1X
Quality of Service (QoS)Yes
DimensionsVaries by model
WeightVaries by model
Humidity10% to 90% non-condensing
Power SupplyInternal
Power ConsumptionVaries by model
Jumbo Frame SupportUp to 9216 bytes

Related product manuals