Access Control
IPv4-based ACLs
Cisco 500 Series Stackable Managed Switch Administration Guide 588
27
-
Shutdown
—Drop packet that meets the ACE criteria and disable the port
to which the packet was addressed. Ports are reactivated from the Port
Management page.
• Logging—Select to enable logging ACL flows that match the ACL rule.
• Time Range—Select to enable limiting the use of the ACL to a specific time
range.
• Time Range Name—If Time Range is selected, select the time range to be
used. Time ranges are defined in the Configuring System Time section.
• Protocol—Select to create an ACE based on a specific protocol or protocol
ID. Select Any (IPv4) to accept all IP protocols. Otherwise select one of the
following protocols from the drop-down list Selected from list:
-
ICMP
—Internet Control Message Protocol
-
IGMP
—Internet Group Management Protocol
-
IP in IP
—IP in IP encapsulation
-
TCP
—Transmission Control Protocol
-
EGP
—Exterior Gateway Protocol
-
IGP
—Interior Gateway Protocol
-
UDP
—User Datagram Protocol
-
HMP
—Host Mapping Protocol
-
RDP
—Reliable Datagram Protocol.
-
IDPR
—Inter-Domain Policy Routing Protocol
-
IPV6
—IPv6 over IPv4 tunneling
-
IPV6:ROUT
—Matches packets belonging to the IPv6 over IPv4 route
through a gateway
-
IPV6:FRAG
—Matches packets belonging to the IPv6 over IPv4 Fragment
Header
-
IDRP
—Inter-Domain Routing Protocol
-
RSVP
—ReSerVation Protocol
-
AH
—Authentication Header
-
IPV6:ICMP
—Internet Control Message Protocol
To Next Page
Loading...
