Cisco Catalyst 2950 Command Reference

Contents
viii
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-11381-12
permit (MAC access-list configuration) 2-238
persistence 2-240
police 2-241
policy-map 2-243
port-channel load-balance 2-246
profile (interface configuration) 2-248
profile (sequence configuration) 2-250
rate selection 2-252
rate selection profile lock 2-253
rate selection sequence 2-255
rcommand 2-257
remote-span 2-259
rmon collection stats 2-261
service password-recovery 2-263
service-policy 2-265
set 2-266
setup express 2-268
show access-lists 2-270
show auto qos 2-272
show boot 2-275
show class-map 2-277
show cluster 2-279
show cluster candidates 2-282
show cluster members 2-284
show controllers ethernet-controller 2-287
show controllers lre cpe 2-296
show controllers lre actual 2-299
show controllers lre admin 2-302
show controllers lre link monitor 2-304
show controllers lre log 2-307
show controllers lre profile 2-309
show controllers lre sequence 2-312
show controllers lre status 2-314
show controllers lre version 2-319
show controllers utilization 2-320

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz