Cisco Catalyst 3750 User Manual

2-443
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
private-vlan
You can associate a secondary (isolated or community) VLAN with only one primary VLAN. A primary
VLAN can have one isolated VLAN and multiple community VLANs associated with it.
• A secondary VLAN cannot be configured as a primary VLAN.
• The secondary_vlan_list parameter cannot contain spaces. It can contain multiple comma-separated
items. Each item can be a single private-VLAN ID or a hyphenated range of private-VLAN IDs. The
list can contain one isolated VLAN and multiple community VLANs.
• If you delete either the primary or secondary VLANs, the ports associated with the VLAN become
inactive.
A community VLAN carries traffic among community ports and from community ports to the
promiscuous ports on the corresponding primary VLAN.
An isolated VLAN is used by isolated ports to communicate with promiscuous ports. It does not carry
traffic to other community ports or isolated ports with the same primary vlan domain.
A primary VLAN is the VLAN that carries traffic from a gateway to customer end stations on private
ports.
Configure Layer 3 VLAN interfaces (SVIs) only for primary VLANs. You cannot configure Layer 3
VLAN interfaces for secondary VLANs. SVIs for secondary VLANs are inactive while the VLAN is
configured as a secondary VLAN.
The private-vlan commands do not take effect until you exit from VLAN configuration mode.
Do not configure private-VLAN ports as EtherChannels. While a port is part of the private-VLAN
configuration, any EtherChannel configuration for it is inactive.
Do not configure a private VLAN as a Remote Switched Port Analyzer (RSPAN) VLAN.
Do not configure a private VLAN as a voice VLAN.
Do not configure fallback bridging on switches with private VLANs.
Although a private VLAN contains more than one VLAN, only one STP instance runs for the entire
private VLAN. When a secondary VLAN is associated with the primary VLAN, the STP parameters of
the primary VLAN are propagated to the secondary VLAN.
For information about configuring host ports and promiscuous ports, see the switchport mode
private-vlan command.
For more information about private-VLAN interaction with other features, see the software
configuration guide for this release.

Cisco Catalyst 3750 Specifications

General

Device Type	Switch
Switching Capacity	32 Gbps
Forwarding Rate	38.7 Mpps
Stacking Bandwidth	32 Gbps
RAM	128 MB
Jumbo Frame Support	Yes
Switch Type	Managed
Model	Catalyst 3750 Series
Uplink Interfaces	SFP
Form Factor	Rack-mountable
MAC Address Table Size	12, 000 entries
Routing Protocol	RIP, OSPF, EIGRP
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Layer 3 switching, Layer 2 switching, auto-negotiation, BOOTP support, ARP support, VLAN support, auto-uplink (auto MDI/MDI-X), IGMP snooping, traffic shaping, MAC address filtering, Quality of Service (QoS), Jumbo Frames support, MLD snooping, Dynamic ARP Inspection (DAI), Cisco EnergyWise technology
Power over Ethernet (PoE)	PoE
Operating Temperature	-5 - 45 °C
Operating Humidity	10% to 85% non-condensing