2-535
Catalyst 3750 Switch Command Reference
OL-8552-07
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
show dot1x
SuppTimeout = 30
ReAuthPeriod = 3600 (Locally configured)
ReAuthMax = 2
MaxReq = 2
TxPeriod = 1
RateLimitPeriod = 0
Mac-Auth-Bypass = Enabled
Critical-Auth = Enabled
Critical Recovery Action = Reinitialize
Critical-Auth VLAN = 10
Guest-Vlan = 15
Dot1x Authenticator Client List
-------------------------------
Domain = DATA
Supplicant = 0000.aaaa.bbbb
Auth SM State = AUTHENTICATED
Auth BEND SM Stat = IDLE
Port Status = AUTHORIZED
Authentication Method = MAB
Vlan Policy = 20
This is an example of output from the show dot1x interface interface-id statistics command. Table 2-26
describes the fields in the display.
Switch> show dot1x interface gigabitethernet1/0/2 statistics
Dot1x Authenticator Port Statistics for GigabitEthernet1/0/2
--------------------------------------------
RxStart = 0 RxLogoff = 0 RxResp = 1 RxRespID = 1
RxInvalid = 0 RxLenErr = 0 RxTotal = 2
TxReq = 2 TxReqID = 132 TxTotal = 134
RxVersion = 2 LastRxSrcMAC = 00a0.c9b8.0072
Ta b l e 2-26 show dot1x statistics Field Descriptions
Field Description
RxStart Number of valid EAPOL-start frames that have been received.
RxLogoff Number of EAPOL-logoff frames that have been received.
RxResp Number of valid EAP-response frames (other than response/identity frames) that
have been received.
RxRespID Number of EAP-response/identity frames that have been received.
RxInvalid Number of EAPOL frames that have been received and have an unrecognized
frame type.
RxLenError Number of EAPOL frames that have been received in which the packet body
length field is invalid.
RxTotal Number of valid EAPOL frames of any type that have been received.
TxReq Number of EAP-request frames (other than request/identity frames) that have
been sent.
TxReqId Number of Extensible Authentication Protocol (EAP)-request/identity frames
that have been sent.
To Next Page
Loading...
Need help?
General
