The passwords must comply with the following requirements:
It cannot contain username or reversed username.
It cannot contain any of the following strings: cisco, sciatl, ocsic,
Itaics, atlsci, icslta, or any string achieved by full or partial
capitalization of letters.
No letter is repeated more than three times in a row.
Must contain a minimum of four characters.
The passwords must comply with the following requirements:
It cannot contain username or reversed username.
It cannot contain any of the following strings: cisco, sciatl, ocsic,
Itaics, atlsci, icslta,or any string achieved by full or partial
capitalization of letters.
No letter is repeated more than three times in a row.
Must contain a minimum of eight characters.
Must contain a minimum of three of the following types of
characters: capital letters, small letters, digits, and special
characters.
Traps
Sets the destination IP address for SNMP
trap messages for system events (for
example, fault messages).
Up to 12 digits in length, e.g.,
155.128.100.200
You can choose to Insert or Delete entries.
Up to 25 entries can be assigned to the Trap
IP Address and Community String fields.
To add a new entry, press Ins and enter the
new entry in the IP Address or Community
String field. To delete an existing entry,
scroll to the IP address or community string
you want to delete and press Del.
Sets the Community string for the Trap IP
Address.
Public or custom string. Up to
35 characters. The default is:
public.
To Next Page
Loading...
Need help?
General
