Cisco D9854 Installation And Configuration Guide

343
Alarm
Message
Type
Message
Cause/Remedy
Description
Severity
ID
FEC FPGA
Status
(D9854-I only)
Set
FEC FPGA failed
to start
Cause: Hardware
issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is
loaded, but
failed to start
(not ready).
Major
92400
FEC FPGA
Status
(D9854-I only)
Set
FEC FPGA access
failed
Cause: Hardware
issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is
loaded and
started,but
attempt to read
configuration
registers failed.
Major
92400
FEC FPGA
Status
(D9854-I only)
Set
FEC FPGA
initialization failed
Cause: Hardware
issue.
Remedy: Ensure
that the USB Flash
is installed,
formatted, and the
image is loaded.
Also, ensure that
the FEC FPGA is
installed and the
CPLD is properly
programmed.
FEC FPGA is
loaded and
started, but
initial
parameter
setup failed.
Major
92400
FEC FPGA
Status
(D9854-I only)
Clear
FEC FPGA is
running OK
–
FEC FPGA is
loaded, started,
initialized, and
is fully
operational.
Major
92400

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C