Cisco D9854 Installation And Configuration Guide

Chapter 6 Service and Maintenance
354
Warning
Message
Type
Message
Cause/Remedy
Description
ID
CAT timeout #
Set
CAT timed out
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
Conditional Access
Table was never
received.
76000
CAT timeout #
Set
CAT is lost
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
No longer receiving
Conditional Access
Table.
76000
CAT timeout #
Clear
CAT fault cleared
–
–
76000
DRT timeout #
Set
DRT # timed out
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
Disaster Recovery
Table was never
received.
77000
DRT timeout #
Set
DRT # is lost
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
No longer receiving
Disaster Recovery
Table.
77000
DRT timeout #
Clear
DRT fault cleared
–
–
77000

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C