Cisco D9854 Installation And Configuration Guide

353
Warning
Message
Type
Message
Cause/Remedy
Description
ID
PAT timeout #
Set
PAT # is lost
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
No longer receiving
Program Association
Table.
67000
68000
69000
70000
71000
72000
73000
74000
PAT timeout #
Clear
PAT fault cleared
–
–
67000
68000
69000
70000
71000
72000
73000
74000
NIT timeout #
Set
NIT timed out
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
Network Information
Table was never
received.
75000
NIT timeout #
Set
NIT is lost
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning.
If the problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
No longer receiving
Network Information
Table.
75000
NIT timeout #
Clear
NIT fault cleared
–
–
75000

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C