Cisco D9854 Installation And Configuration Guide

359
Warning
Message
Type
Message
Cause/Remedy
Description
ID
Restore Failure
Reason
Set
Not Accepted
Cause: Import file is
either for a different
product or the structure
was not compatible with
this unit.
Remedy: Verify that the
correct import file is
being used and was
created by this product,
and that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Import file was
rejected and import
did not occur
89000
Restore Failure
Reason
Set
Bad Content
Cause: Import file may
be corrupted, or from a
different version of
application software.
Remedy: Verify that the
correct import file is
being used and was
created by this product,
and that the file
structure has not been
corrupted. If the
problem persists, notify
Cisco Services.
Item in import file is
not valid for this
software and import
did not occur
89000
SDI Aud SFR
Data
Set
SDI Audio
sampling
frequency
mismatch
Cause: The SDI audio
groups are not
configured correctly, or
the transport stream has
changed the sampling
rate of one of the audio
streams.
Remedy: Configure the
SDI audio groups to
ensure that all audio
channels in a group
have the same sampling
frequency rate.
All audio channels in a
given audio group
within an SDI do not
have identical
sampling rate.
90000
SDI Aud SFR
Data
Clear
SDI Audio SFR
Mismatch
Cleared
–
–
90000

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C