Cisco D9854 Installation And Configuration Guide

Chapter 6 Service and Maintenance
364
Warning
Message
Type
Message
Cause/Remedy
Description
ID
Network ID
Mismatch TS1
Clear
Original Network
ID in NIT and
SDT matched
–
The original network
ID in NIT matches the
original network ID in
SDT.
98000
D/R No Search
Path
Set
No Search
Path:No Backups
Cause: No tuning
configurations found in
the Disaster Recovery
Table, or only a single
backup location is found
in the Disaster Recovery
Table that matches the
origin.
Remedy: Contact your
PNC uplink
administrator.
The disaster recovery
search path cannot be
generated.
99310
D/R No Search
Path
Clear
Search path exists
–
The error is cleared
before disaster
recovery search path is
generated.
99310
D/R Malformed
DRT
Set
Malformed DRT
Cause: The Disaster
Recovery Table received
from the uplink is
invalid and cannot be
used.
Remedy: Ensure that a
valid Disaster Recovery
Table is received from
the uplink, or switch to
the Local profile. If you
switch to the Local
profile, the warning
message may persist if
you switch back to the
Uplink profile. Contact
your PNC uplink
administrator.
The Disaster Recovery
Table received from
uplink is invalid.
99320
D/R Malformed
DRT
Clear
DRT accepted
–
The error is cleared
before disaster
recovery search path is
generated.
99320

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C