Cisco D9854 Installation And Configuration Guide

365
Warning
Message
Type
Message
Cause/Remedy
Description
ID
D/R No DRT
Received
Set
No DRT
Received
Cause: Did not receive
the Disaster Recovery
Table from the uplink.
Remedy: Ensure that a
valid Disaster Recovery
Table is received from
the uplink, or switch to
the Local profile. If you
switch to the local
profile, the warning
message may persist if
you switch back to
Uplink profile and
Disaster Recovery Table
is still not received.
Contact your PNC
uplink administrator.
The unit is not
receiving the Disaster
Recovery Table from
the uplink.
99330
D/R No DRT
Received
Clear
DRT Table
Received
–
The error is cleared
before disaster
recovery search path is
generated.
99330
D/R Invalid
Tuning
Set
Invalid Tuning
for Backup (list of
affected D/R
Backup
Transports)
Cause: Any of the
possible tuning
validation failure
reasons not described by
the other disaster
recovery tuning
validation related
warnings (such as, a
tuner hardware failure).
Remedy: Export the
diagnostics file
(Support > Service
Action) and contact
Cisco Services.
The disaster recovery
backup transport
failed tuning
validation due the
reasons that are
described in the
exported diagnostics
file (Support > Service
Actions). For more
information, see
Loading a Software
Version (on page 302).
99340
D/R Invalid
Tuning
Clear
warning cleared
–
The error is cleared
before re-validating
the tuning.
99340

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C