Cisco D9854 Installation And Configuration Guide

367
Warning
Message
Type
Message
Cause/Remedy
Description
ID
D/R Rolloff
Invalid
Set
Rolloff factor
invalid for DVB
for Backup (list
of affected DR
Backup
Transports)
Cause: The selected
Rolloff factor value for
the identified Backup
Transport is not valid
for the selected DVB
system.
Remedy: Contact your
PNC uplink
administrator to check
the tuning parameters
and RF Input settings for
the identified disaster
recovery backup
transports.
The Disaster Recovery
Table received from
the uplink is invalid.
99370
D/R Rolloff
Invalid
Clear
cleared
–
The error is cleared
before re-validating
tuning.
99370
D/R LO Freq
Mismatch
Set
LO frequency
mismatches
tuning for
Backup (list of
affected DR
Backup
Transports)
Cause: The selected LO
Frequency from RF
Input settings is in
conflict with the
calculated L-Band
frequency of the Backup
Transport(s) that use
that RF Input.
Remedy: Contact your
PNC uplink
administrator to check
the tuning parameters
and RF Input LO
frequencies for the
identified disaster
recovery backup
transports.
The Disaster Recovery
Table received from
the uplink is invalid.
99380
D/R LO Freq
Mismatch
Clear
cleared
–
The error is cleared
before re-validating
tuning.
99380

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C