Cisco D9865 Installation And Configuration Guide

5-2
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Logging on to the Web GUI
• Performing Service Actions, page 5-56
Logging on to the Web GUI
Proceed as follows to log on to the Web GUI:
Step 1 Open MS Internet Explorer.
Step 2 Type the IP address of the D9865 Satellite Receiver in the address bar and press Enter.
Step 3 In the Username and Password field, enter the username and password.
The username and password are case-sensitive. The default username is admin and the default password
is localadmin. If you have forgotten your username and password, you can reset them to its factory
defaults from the on-screen menu of the D9865 Satellite Receiver. For more information, refer to
Viewing System Information, page 4-57.
Tip The password and user name will be remembered for the whole web session. Close the web
browser if you want to prevent others from accessing the settings of the D9865 Satellite
Receiver.
If your session expires, you must refresh the browser and log back in.
Step 4 Click Log In.
Note If you select Remember username, the user name will be remembered the next time you log
into the web GUI.

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English