3-3
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 3 Front Panel Operation
About the Front Panel
CI Slot
The CI Slot allows the use of CAM (Conditional Access Module) Smart Card to decrypt purchased
programming. For setup information, see Viewing DVB-CI Information, page 4-62 and Configuring the
Common Interface (CI) Information, page 5-22. For a list of supported CAMs, refer to Common
Interface Modules, page 3-4.
Keyboard Display
Press the MENU and SELECT buttons simultaneously on the Front Panel to display a keyboard on the
TV monitor. The keyboard allows alphabetical and numerical character entry in menu fields using the
front panel. Alternatively, press the red button on the remote control.
You must have a menu field selected (i.e., must be in edit mode) to display the keyboard.
1. Use the arrow buttons to move along the keyboard.
2. Press OK to select a number or letter for each entry.
Setting the TV Video Format
The video format is set to the standard format for your country. Check with your satellite or local service
provider before changing this setting to ensure it is set correctly. If you are instructed to change this
setting for your TV set:
Step 1 Press the SELECT and buttons on the receiver front panel at the same time.
Step 2 Press SELECT and again. The video format is displayed on the receiver front panel (e.g., NTSC,
PAL, etc).
Step 3 Press until you display your video format. Each change is viewable on-screen.
Step 4 Press SELECT to save the setting and re-display the selected channel.
Note You must be in video mode (i.e., on-screen menus not displayed) to perform this function on the
receiver front panel.
Note This function is not available through the remote control.
To Next Page
Loading...
Need help?
General
