5-36
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Setting Up IP Information
Setting Up IP Information
To Configure Management and Data Port Settings
Proceed as follows to configure management and data port settings:
From the user interface of the D9865, click System Settings > System > IP Settings. The IP Settings
page is displayed.
For the Management and Data Port Settings, set the following parameters:
Selection Description
IP Address Sets the IP Address for its participation in a Network environment.
The IP Address is 12 digits in length (###.###.###.###).
IP Mask Sets Subnet Mask for its participation in a Network environment.
You can enter a value in the range from 8 to 32.
Gateway Address Sets the Network Gateway Address on the Network, used to expose
the receiver to a WAN.
To Next Page
Loading...
