5-44
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Viewing the Alarm/Warning Status
To Set up Warnings
Proceed as follows to set up the warnings:
From the Setup - Alarm Setup page, click the Warning Setup link at the bottom left hand corner of the
page. The Setup - Warning Setup page is displayed.
Step 7 The Warning Setup area displays a list of alarm/fault messages. For more information on warning
messages, refer to Warning Messages, page 6-10.
Step 8 From the Enable/Disable drop-down list, choose Yes to report the warning message. Choose No and the
fault will not be reported.
Step 9 From the Trap drop-down list, choose Yes and the SNMP trap message will be sent to the trap
destination; otherwise the fault message will be ignored.
Note This is for D9865D only.
Step 10 Click the Trap Configuration link to view and/or modify trap destinations. The link will open the SNMP
page. For more information, refer to Setting Up SNMP and Trap Destinations, page 5-38.
Step 11 Click Apply.
To Next Page
Loading...
Need help?
General
