4-40
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Step 2 Select Ye s to reboot. Otherwise, select No.
Resetting the Web GUI Login Information
The Reset Login (RstLogin) is used for resetting the username and password used for Web GUI login
to its default values. The default username is admin and the default password is localadmin.
To reset the login:
Step 1 From the Advanced Administration screen, press the blue button (RstLogin). A message appears
confirming that you want to reset the password to its default values.
Step 2 Select Ye s . Otherwise, select No.
Setting up POV Mode
Proceed as follows to configure the POV Mode:
Note Ensure the POV Mode setting is set to Advanced.
Step 1 From the Administration screen, press the blue button (POVAdv).
Step 2 Select the Conditional Access type (CA Mode) that determines which programs can be viewed via the
satellite receiver. Select Std (preferred) or Open. The default is Std.
Caution In Open mode, the receiver ignores inconsistent scrambling descriptions within the signal.
Operating in this mode may cause the decoder not to respond to certain advanced uplink
controlled features, such as service replacement.
To Next Page
Loading...
Need help?
General
