5-56
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Performing Service Actions
Performing Service Actions
To Load a Software Version
Proceed as follows to load a software version:
Step 1 From the user interface of the D9865, choose Support > Service Actions. The Service Actions page is
displayed.
Step 2 From the S/W Version drop-down list, choose a different application version application to load to your
receiver. Click Select and Reboot to load the selected application version and reboot the receiver.
Click Erase to remove the selected application version. You will be prompted to continue or not. Press
OK to continue the deletion.
Step 3 Click Factory Reset to perform a reset of receiver settings back to the factory set (default) values. A
warning message prompts you to confirm the operation. Click OK to continue or No to cancel the
operation.
Step 4 Click Reboot Receiver to reboot the receiver. You will be prompted to verify the operation. Click Yes
to reboot the receiver or No to cancel the operation.
To Change the Download Application
In the Download APP area, click Browse to select the new version of the D9865 Satellite Receiver’s
software application. The Choose File dialog opens. Select the upgrade file and click Open. Click
Download to download the selected upgrade file.
To Next Page
Loading...
Need help?
General
