4-18
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Step 3 Press the green button (Save) to save and apply the settings to the receiver.
Selecting the Active Preset
To change the displayed preset to the Active preset or to select a different preset as the active preset:
Step 1 From the Tuning/Preset screen, press the yellow button (Preset).
Step 2 Enter the preset in the Preset field that you want to activate. Enter the number directly using the numeric
keypad on the remote control or use the
buttons to change the number one digit at a time.
Alternatively, press the red button (keyboard) to enter the preset using an on-screen keyboard.
Step 3 Select Activate (blue button) to choose the preset. This will activate the currently displayed preset as the
active preset.
You will be prompted to accept the new preset and warned that service interruption will occur.
Step 4 Select OK to proceed or EXIT to cancel the operation.
Step 5 Press MENU to go to the previous menu.
Note It will take up to 30 seconds for signal acquisition to occur. It can take longer if the symbol rates
are low.
Selection Options Description
Preset Number 1 to 64 Enter or select the preset number.
Preset Name Enter name Set the preset network name.
LNB Configuration 1 to 10 Enter or select the LNB configuration.
Modulation Type DVB-S
DVB-S2
Select the modulation scheme.
Downlink (Freq) Enter number For C-Band,
Downlink Freq = LO Freq - L-band Freq.
For Ku-Band,
Downlink Freq = LO Freq + L-band Freq.
Symbol Rate 1.0 to 45.0
1.0 to 31.0
Range for DVB-S in MS/s.
Range for DVB-S2 in MS/s.
NetId Enter number Obtain the number from your service provider.
Last Activated Preset Indicates the number of the last activated preset.
Signal Lock Indicates signal synchronization status.
Signal Level Indicates the relative strength of the received
signal, in the range from 0 to 100.
To Next Page
Loading...
Need help?
General
