4-55
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Performing Over-the-Air Downloads
Over-the-air downloads are controlled by the uplink. The DL Mode affects unforced over-the-air
downloads. This feature is set to Always so that the uplink performs downloads to the receiver when
necessary. The Restart DL forces over-the-air downloads. Use this feature if you want to control
over-the-air downloads at the receiver or restart a download due to signal interruption. The Abort DL
aborts the download at any time.
To configure and/or restart an over-the-air download:
Step 1 From the Advanced Setup screen, select Download and press OK.
Step 2 Select the DL Mode. The options are Always, Once, or Never. The DL Mode only affects unforced
over-the-air downloads. This feature is set to Always for normal operation.
Step 3 Press OK to save the DL mode changes.
DL Mode Setting Description
Always Normal (default) setting for everyday operation. Downloads are performed
as necessary by the uplink. After the download is completed, the unit will not
reboot.
If an unforced download is in progress and you change the DL Mode from
Always to Never, the download will abort.
If an unforced download is in progress and you change the DL Mode from
Always to Once, the download will restart.
Once Use this setting if you want to perform a download once only. After the
download is completed, the unit will reboot and the state changes to Never.
If an unforced download is in progress and you change the DL Mode from
Once to Never, the download will abort.
If an unforced download is in progress and you change the DL Mode from
Once to Always, the download will restart.
Never Use only when downloads are not required.
If an unforced download is in progress and you change the DL Mode from
Never to Always or Once, the download will start.
To Next Page
Loading...
Need help?
General
