Cisco D9865 Installation And Configuration Guide

4-54
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Step 4 Press the yellow button (Alarm) to configure the alarm settings. Press the blue button (Warning) to
configure the warning settings.
To configure the Alarm settings
From the Alarms & Warnings screen, press the yellow button (Alarm) on the remote control.
Set the following alarm options:
To configure the Warning settings
From the Alarms & Warnings screen, press the blue button (Warning) on the remote control.
Set the following warning options:
Alarm Setting Description
Alarm Name Displays a list of the alarm/fault messages. You can scroll through
the list using the
 buttons.
Alarm Enable When set to Yes , the alarm message will be reported. When set to
No, the fault will not be reported.
Send Trap (D9865D only) When set to Yes , the SNMP trap message will be sent to the trap
destination; otherwise the fault message will be ignored.
Warning Setting Description
Warning Name Displays a list of the warning messages. You can scroll through the
list using the
 buttons.
Warning Enable When set to Yes, the warning message will be reported. When set to
No, the fault won’t be reported.
Send Trap (D9865D only) When set to Yes , the SNMP trap message will be sent to the trap
destination; otherwise the warning message will be ignored.

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English