Cisco D9865 Installation And Configuration Guide

6-10
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 6 Service and Maintenance
Warning Messages
Warning Messages
Table 1-2 displays a list of the available messages and their default warning status.
Table 6-2 D9865 Satellite Receiver Warning Messages
Warning Set Message Cause Remedy Clear Message
Transport Error Continuity Count Error Transport packet
continuity count jumped
due to a possible uplink
or signal issue. Possible
packet loss.
Clear warnings, reset
the unit, and notify
Cisco customer support
if the problem persists.
Continuity Count Error
Cleared
Transport Error Buffer Overflow The transport stream is
faster than the
maximum buffer or the
decode engines are
having difficulty
handling the data sent to
them. This is due to a
possible uplink or signal
issue.
Clear warnings, reset
the unit, and notify
Cisco customer support
if the problem persists.
Buffer Overflow
Cleared
Transport Error Transport Error
Indicator
Transport packets are
marked as “errored”
upstream of the decoder
due to a possible uplink
or signal issue.
Clear warnings, reset
the unit, and notify
Cisco customer support
if the problem persists.
Transport Error
Indicator Cleared
Video Format
Mismatch
Video format mismatch The video format is
mismatched.
None. Video format match
VBI Data 2nd VBI PID attempt to
write same line
Conflicting VBI data on
second VBI PID due to
an uplink configuration
issue.
Contact uplink to verify
expected VBI settings.
Line Collision Cleared
TDT/SDT/PMT/
PAT/NIT/CAT/ECT
timeout
tdt/nit/cat/ect timed out
sdt/pmt/pat # timed out
Uplink is not sending or
is sending
intermittently.
Clear warning. If the
problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
tdt/sdt/pmt/pat/nit/cat/
ect fault cleared
TDT/SDT/PMT/
PAT/NIT/CAT/ECT
timeout
tdt/sdt/pmt/pat/nit/cat/
ect is lost
Uplink is not sending or
is sending
intermittently.
Clear warning. If the
problem persists,
determine if uplink is
sending the current SI
information table.
Disable the warning if
not using the table.
tdt/sdt/pmt/pat/nit/cat/
ect fault cleared

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English