Cisco D9865 Installation And Configuration Guide

6-11
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 6 Service and Maintenance
Warning Messages
Memory Usage Host Excessive
(stack/partition)
memory usage
SW exceeding
allowable memory
usage due to a software
issue.
Clear warnings, reset
the unit, and notify
customer service if the
problem persists.
Normal (stack/partition)
memory usage
MPE near capacity Approaching current
capacity
Decoder is busy
processing or handling
other services and it is
approaching the limit of
safe CPU load for MPE
processing.
Reduce or stop MPE
service content.
None.
Ethernet MAC
Failure
MAC configuration
failed
Errors, such as a Fatal
Bus Error, due to a
possible hardware issue.
Clear warnings, reset
the unit, and notify
customer service if
problem persists.
Failure cleared
Ethernet PHY
Failure
Marvel switch
configuration failed
Related to MII register
read/write failures, due
to a possible hardware
issue.
Clear warnings, reset
the unit, and notify
Cisco customer support
if the problem persists.
PHY failure monitoring
reset
Ethernet Port 1 or
Ethernet Port 2
ETH Port 1 or 2 Link
Down
Ethernet port 1 or 2 is
not connected.
Connect Ethernet port 1
or 2.
ETH Port 1 or 2 Link
Up
FW: Resource Use
PRI
Memory or List Near
Full
Software exceeding
allowable usage of
internal constructs, due
to a possible software
issue.
Clear warnings, reset
the unit, and notify
Cisco customer support
if the problem persists.
None.
Backup Operation
State
Backup Active Backup operation
started.
None. Backup Complete
Backup Failure
Reason
Internal Error Software error occurred
due to a possible
software issue.
Clear warning, reset the
unit, and notify Cisco
customer support if the
problem persists.
Auto reset after timeout
Backup Failure
Reason
FTP Failed FTP failed due to a
possible software issue.
Check FTP
configuration, reset
unit, and notify Cisco
customer support if
problem persists.
Auto reset after timeout
Restore Failure
Reason
Not Accepted Software error occurred
due to a possible
software issue.
Clear warning, reset the
unit, and notify Cisco
customer support if the
problem persists.
Auto reset after timeout
Restore Failure
Reason
Bad Content Software error occurred
due to a possible
software issue.
Clear warning, reset the
unit, and notify Cisco
customer support if the
problem persists.
Auto reset after timeout
Warning Set Message Cause Remedy Clear Message

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English