Cisco D9865 Installation And Configuration Guide

6-12
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 6 Service and Maintenance
Warning Messages
Restore Failure
Reason
FTP Failed FTP failed due to a
possible software issue.
Check FTP
configuration, reset
unit, and notify Cisco
customer support if
problem persists.
Auto reset after timeout
HDMI:Not an Auth
Device
HDCP authentication
failed
HDMI monitor is not
authorized to receive
HDMI content and does
not contain valid HDCP
keys. Video decode is
disabled.
Disconnect HDMI
monitor to restore video
decode or use an HDMI
monitor that properly
supports HDCP.
HDMI monitor is not
connected.
Connect an HDMI or
DVI capable monitor, if
desired.
HDCP authentication
success
HDMI:Not an Auth
Device
Receiver not HDCP
capable
HDMI monitor is not
authorized to receive
HDMI content and it
does not support HDCP.
Video decode is
disabled.
Disconnect HDMI
monitor to restore video
decode or use an HDMI
monitor that properly
supports HDCP.
HDCP Authentication
Process Not Started
TV-Out Settings
Problem
Invalid configuration
data
Incorrect TV-Out video
setup settings.
Check the video setup
settings: TV Channel
Number and SD Video
Output format. For PAL
device, use channel 21
through 69 and SD
Format PAL-x. For
NTSC device, use
channel 3 or 4 and SD
Format NTSC or
NTSC-J. Notify
customer service if
problem persists.
Valid configuration data
Warning Set Message Cause Remedy Clear Message

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English