Cisco D9865 Installation And Configuration Guide

5-11
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Setting Up Dish Pointing
Step 5 Click Apply.
To set up the dish in Installer Action mode:
Proceed as follows to set up the dish in Installer Action mode:
Step 1 From the Dish Pointing page, click the Installer Action link at the bottom right hand corner of the page.
Step 2 In the Satellite Number field, enter the satellite number identifying the saved satellite location, as
defined by the dish motor manufacturer. You can enter a value in the range from 1 to 255.
Step 3 From the Installer Action drop-down list, choose the satellite installer action. The following table
describes the actions available:
LDPC ER Indicates the bit rate of the input stream of the LDPC error
correction stage (DVB-S2 only).
Packet ER Indicates the current Packet Error Rate.
PV BER Indicates the PV (Post-Viterbi) BER for the received signal
(DVB-S).
RF(1) Power Displays the LNB Power setting. The LNB Power setting
determines if power is provided via the RF1 Input to an external
LNB connection.
LNB Status Indicates the current LNB connection status (No Load, Overloaded,
OverTemp, Short Circuit, Disabled, Normal, or N/A).
Parameter Description

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English