5-12
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Setting Up Dish Pointing
Step 4 From the DiSEqC drop-down list, choose to enable or disable the Digital Satellite Equipment Satellite
Control, level 1.2.
Note This must be enabled to control the DiSEqC switch. LNB Power must be on to use this setting.
Refer to http://www.eutelsat.com/satellites/4_5_5.html for more information.
Step 5 In the Absolute Position field, enter the absolute position of the satellite, in degrees. You can enter a
value in the range from 0.0 to 75.0 degrees.
Step 6 The Tuner Performance area is the same as the Tuner Performance section in the User Action mode.
For more information, see above.
Step 7 Click Apply.
Options Description
Continuous West Movement Moves the dish west until it reaches its limit. Ensure that the dish
can move to its limit without any obstructions.
Continuous East Movement Moves the dish east until it reaches its limit. Ensure that the dish can
move to its limit without any obstructions.
Stop Move Stops movement of the dish.
Goto Absolute Position West Moves the dish to the Absolute west position set above.
Goto Absolute Position East Moves the dish to the Absolute east position set above.
Goto Reference Moves the dish to a reference defined by the dish motor
manufacturer.
Goto Satellite Moves the dish to the selected pre-stored satellite position. Satellite
positions are stored in the dish motor, if supported, not in the
receiver.
Store Satellite Stores the current dish position as a Satellite Number, if supported
by the dish motor.
Clear Limits Clears the dish east and west limits stored in the dish motor.
Store East Limits Stores the current position as the east limit in the dish motor.
Store West Limits Stores the current position as the west limit in the dish motor.
Calculate Position Updates the position of the dish according to the current position.
For more information, refer to the dish manual provided by the dish
manufacturer.
None No action is performed.
To Next Page
Loading...
Need help?
General
