5-43
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Viewing the Alarm/Warning Status
Setting Up Alarms and Warnings
To Set Up Alarms
Proceed as follows to set up the alarms:
Step 1 From the user interface of the D9865, choose System Settings > Alarms > Setup. The Setup - Alarm
Setup page is displayed.
Step 2 The Alarm Setup area displays a list of alarm/fault messages. For more information on alarm messages,
refer to Alarm Messages, page 6-1.
Step 3 From the Enable/Disable drop-down list, choose Yes to report the alarm message. Choose to No and the
fault won’t be reported.
Step 4 Set Trap to Ye s and the SNMP trap message will be sent to the trap destination; otherwise the fault
message will be ignored.
Note This is for D9865D only.
Step 5 Click the Trap Configuration link to view and/or modify trap destinations. The link will open the SNMP
page. For more information, refer to Setting Up SNMP and Trap Destinations, page 5-38.
Step 6 Click Apply.
To Next Page
Loading...
Need help?
General
