Cisco D9865 Installation And Configuration Guide

4-37
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Menu transparency None, 25%, 50%, 75%,
90%
Set the transparency level of the
menus displayed on-screen.
For example, if set to None,
menus are solid and the video
appears behind the menus. If set
to 25%, menus are clear and the
video is visible through the
menus.
None
IR remote Enable Set to Enable to control the
receiver using the remote
control. By default, the receiver
is shipped with the remote
control enabled.
Note The EPG functions are
only available using the
IR remote control.
Enable
Disable Set to Disable if you want to
disable the remote control and
use the front panel controls only.
Date Format YYYY/MM/DD,
DD/MM/YYYY,
MM/DD/YYYY
Current date information is
displayed in the Active Alarm
and Active Warning screens.
YYYY/MM/D
D
Time format 24 Hr, 24 Hr
SuspendZero, 12 Hr, 12
Hr SuspendZero
Time information is displayed in
the Active Alarm and Active
Warning screens.
Time information is normally
broadcast as part of the
transmitted digital signal, and is
usually the broadcaster local
time relative to Greenwich Mean
Time (GMT).
24 Hr
Time offset Adjusted in one hour
increments, from -12:00
to +13:00, and GMT.
Displays the time zone offset
instead of the true local time. If
the current broadcast time is not
your local time, you must change
this time setting.
+05:30
Actual Lock Level Displays the current lock level.
Adv Admin Displays the Advanced
Administration screen. For more
information, see Changing the
Lock Level Password,
page 4-38.
Selection Options Description Default

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English