Cisco D9865 Installation And Configuration Guide

4-49
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
From the SNMP Setup screen, press the yellow button (Trap Dest) to view trap destinations.
The Trap Destination Setup screen displays a list of trap destination addresses and the associated
community string.
Adding Trap Destinations
Proceed as follows to add trap destinations:
Step 1 From the Trap Destination Setup screen, press the green button (Add) to add a trap destination address.
Step 2 The following table describes each of the available options:
Selection Options Description
Trap Destination
Address
Up to 12 digits in length (e.g.,
155.128.100.200)
Enter the destination for SNMP trap
messages for events (i.e., fault messages).
Community String public or custom string. Up to 31
characters.
Set the community string for the trap IP
address above. The default is public.

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English