2-85
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
frame interval
frame interval
To configure the rate at which an IP Service Level Agreements (SLAs) Metro-Ethernet 3.0 (ITU-T
Y.1731) operation sends synthetic frames, use the frame interval command in the IP SLA Y.1731 delay
or IP SLA Y.1731 loss configuration mode. To return to the default, use the no form of the command.
frame interval milliseconds
no frame interval milliseconds
Syntax Description
Defaults The default for the frame interval is 1000 milliseconds.
Command Modes IP SLA Y.1731 delay configuration (config-sla-y1731-delay)
IP SLA Y.1731 loss configuration (config-sla-y1731-loss)
Command History
Usage Guidelines Use this command to change the gap between successive synthetic frames sent in an Ethernet delay,
delay variation, or frame loss operation from the default (1000 ms) to the specified value.
Frames will be sent at a given frequency for the lifetime of the operation. For example, a delay operation
with a frame interval of 1000 ms sends a frame once every second, for the lifetime of the operation.
Configure this command on the sender Maintenance End Point (MEP).
Examples The following example shows how to configure the sender MEP for a single-ended IP SLAs Ethernet
delay operation with a frame interval of 100 ms:
Switch(config-term)# ip sla 10
Switch(config-ip-sla)#ethernet y7131 delay dmm domain xxx evc yyy mpid 101 cos 3 source
mpid 100
Switch(config-sla-y1731-delay)# frame interval 100
Switch(config-sla-y1731-delay)# frame size 32
milliseconds Length of time in milliseconds (ms) between successive synthetic frames. The
default is 1000. The valid values are:
• 10--Frame interval is 10 ms
• 100--Frame interval is 100 ms
• 1000--Frame interval is 1000 ms (1 second)
• 20--Frame interval is 20 ms
• 25--Frame interval is 25 ms
• 50--Frame interval is 50 ms
Release Modification
15.2(4)S1 This command was introduced.
To Next Page
Loading...
Need help?
General