Cisco ME 3600X User Manual

2-187
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
network-clock input-source
network-clock input-source
To configure the Synchronous Ethernet (SyncE) input clock and priority, use the network-clock
input-source command in global configuration mode. To remove the priority, use the no form of this
command.
network-clock input-source priority [external] [interface]
no network-clock input-source priority [external] [interface]
Syntax Description
Defaults The SyncE network clock is not configured.
Command Modes Global configuration
Command History
Usage Guidelines During operation, the system selects the network clock based on the priority.
Examples
Example 1 - SYNCE as Clock Source
The following example shows how to configure SyncE as the network clock input source.
Switch(config)# network-clock input-source 1 interface tenGigabitEthernet ?
<0-0> TenGigabitEthernet interface number
priority Sets the priority of the device as a network clock. The range is from 1 to
250, with 1 being the highest priority. Unused network clocks are given
a priority value of 0.
external Specifies the type of external interface:
• BITS
• SSU
• GPS
interface Specifies the type of interface:
• Ethernet
• Sonet
• ToP
Release Modification
15.1(2)EY This command was introduced.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English