Cisco ME 3600X User Manual

B-3
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug etherchannel
debug etherchannel
To enable debugging of the EtherChannel/PAgP shim, use the debug etherchannel command in
privileged EXEC mode. This shim is the software module that is the interface between the Port
Aggregation Protocol (PAgP) software module and the port manager software module. To disable
debugging, use the no form of this command.
debug etherchannel [all | detail | error | event | idb]
no debug etherchannel [all | detail | error | event | idb]
Syntax Description
Note Though visible in the command-line help strings, the linecard keyword is not supported.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug etherchannel command is the same as the no debug etherchannel command.
Related Commands
all (Optional) Displays all EtherChannel debug messages.
detail (Optional) Displays detailed EtherChannel debug messages.
error (Optional) Displays EtherChannel error debug messages.
event (Optional) Displays major EtherChannel event messages.
idb (Optional) Displays PAgP interface descriptor block debug messages.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show etherchannel Displays EtherChannel information for the channel.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English