Cisco ME 3600X User Manual

2-191
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
network-clock wait-to-restore
network-clock wait-to-restore
To configure the time that the switch waits before a previously failed Synchronous Ethernet (SyncE)
input clock must be fault-free before it is considered available as a synchronization source, use the
network-clock wait-to-restore command in global configuration mode. To return to the default value,
use the no form of this command.
network-clock wait-to-restore value
no network-clock wait-to-restore value
Syntax Description
Defaults SyncE wait to restore time is 300 seconds.
Command Modes Global configuration
Command History
Usage Guidelines None.
Examples The following example shows how to configure the wait-to-restore time:
Switch# configure terminal
Switch(config)# network-clock wait-to-restore 50000
Related Commands
value Sets the wait time in seconds. The range is 0 to 86400 seconds. The
default is 300 seconds.
Release Modification
15.1(2)EY This command was introduced.
Command Description
show network-clocks Displays network clock configuration.
show network-clock
synchronization
Displays network clock configuration.
controller BITS
commands
Configures the BITS clock controller characteristics.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English